Hi everyone,

I have problem with Bandicam. After installing of trial version cannot launch this app.

I looked into Event Viewer and there is:

ID of Missing process: 0xe6c
ID of message: d2a40e90-92c5-455c-9489-4eccff6eb69e
ID of Event: 1000

I have OS Windows 10.

Do you have any idea? Someone here who has same problem? I tried reinstall Bandicam and update drivers but without success.

Hi dot.juice,

I'm guessing you already tried the usual steps:
- use latest version of bandicam
- run as admin
- (I guess this is a thing now, so...) run as non-admin
- reboot your system (which you will probably have, at least now)

you seem to be good with computers, so I guess you'll be able to try ending all of the non-critical (not necessary to keep the system running) processes and try again.
Why do this? Sometimes another process interferes with Bandicam, usually that would be the antivirus (if you can't exit out of it, just try disabling) or additional hardware enhancing software.

If this has no effect, please tell us a little about yourself, as described in section 3 of the official MIPFD (most important forum document, aka the rules).
(it's not actually called that)

I hope this proves helpful,
--Zuzu_Typ--

I'm having the same problem.

I downloaded Bandicam to my Windows 10 laptop and double-clicked the "bdcamsetup.exe" to do the installation.

Then I attempted to launch the program by double-clicking the "Bandicam" shortcut left on the desktop by the install program. That shortcut points to the bdcam program inside the Bandicam folder.

When I invoke bdcam (either directly or by means of the shortcut on the desktop), I get the same prompt ("Do you want to allow this app to make changes to your device") ... as if I were invoking the setup program again, rather than the application itself.

I'm unable to launch the application itself

Hello depelton,

Please refer to the linked page below.

https://www.bandicam.com/faqs/disable-u ... t-control/

You can run Bandicam by clicking the "Bandicam(Non-admin)" shortcut if you are using Bandicam 4.0.0.

Thank you.

Бандикам самостоятельно прекращает запись.После начала записи проходит какое-то время и запись заканчивается.Бандикам крякнутый.Для автозавершения записи я поставил лимит в 100гб

Hello ЧЕЛОВЕК,

We are sorry but we are not sure what your problem is.

Please refer to the following page.
https://www.bandicam.com/faqs/cannot-run/

If it does not work, please attach the screenshot of the window of your problem.

Thank you.