bandicut only outputs watemark on already trimmed files
Posted: Wed Nov 11, 2015 2:32 pm
any files sent through bandicut 2.01 twice come out as nothing but a 6~42 sec long water mark
to elaborate, I was editing several 2 hour clips and decided to split them into 30mins each to make it easier to navigate
after splitting them I edited them quiet a bit, lots of little trims here and there, only to realize much later the videos were only being render out for about 6~42 seconds and only the water mark
now I've got 11 of these broken renders
really wished I would of noticed it sooner, though it never crossed my mind to check the files since I did the same thing yesterday in v2.0 with no problems at all
I've gotta re-trim that 10 and a half hours again now
to elaborate, I was editing several 2 hour clips and decided to split them into 30mins each to make it easier to navigate
after splitting them I edited them quiet a bit, lots of little trims here and there, only to realize much later the videos were only being render out for about 6~42 seconds and only the water mark
now I've got 11 of these broken renders
really wished I would of noticed it sooner, though it never crossed my mind to check the files since I did the same thing yesterday in v2.0 with no problems at allI've gotta re-trim that 10 and a half hours again now